Muratec F-320 manual Plug in and power up, Adjust the monitor speaker’s volume, Loading paper

Plug in and power up

1 Plug one end of the telephone line cord into the LINE jack on the machine’s rear side and the other end into a standard telephone wall jack.

2 Plug the non-pronged end of the AC power cord into the AC power cord jack on the right rear side of the machine and the pronged end into a 120 V electrical outlet (preferably on a surge suppressor, as mentioned on page 1.5).

LINE PHONE2 PHONE1

3	Use the AC power switch to turn on your machine. The markings are interna-
	tional standards: I means on, O means off.
	It will take a few seconds for the machine to warm up. The LCD shows:
		** Warming Up **
	When the machine is ready to use (standby mode), you will see:
		Fax Ready
		Jan 1 2001 12:00am

Getting started

Adjust the monitor speaker’s volume

You can set the volume of the monitor speaker.

1	Press MONITOR/CALL on the control panel. You now should hear a dial tone.
	And press		or . The LCD indicates the volume:
		**	Tel Mode **
		Volume:■■ ■■ ■■
2
	To turn the volume up, press .
	To turn the volume down, press .

3 Press MONITOR/CALL again to hang up.

Loading paper

Acceptable paper size and cassette capacity

Paper source	Paper type	Paper size							Capacity
Paper cassette	Plain paper*1	Letter , Legal , Half-letter							500 sheets
		Letter		, Legal			, Half-letter		,
	Plain paper*1, *2	A4	, A5		, A6		, F4	,	50 sheets
Bypass Tray		Executive , Custom-sized*3
	Envelopes*2	DL	, CM10			, Monarch			1 sheet
	Postcard*2	3.9″ ⋅	5.8″		(100 ⋅	148mm)			20 sheets
	Transparency*4	Letter							20 sheets
*1 Paper weight: 60 – 90 g/m2

*2 A4, A5, A6, F4, Executive, DL, CM10, Monarch, Postcard, Custom-sized paper and Transparency can be used only if the optional Printer Controller is attached.

*3 (3.8 – 8.5) inches × (5.5 – 14.0) inches (Width × Length)

*4 We recommend: 3M PP2500 for laser printers or equivalent

Note: Do not use any paper which has been creased, wrinkled or has absorbed any moisture.

1.7