Muratec F-320 manual Sending a fax using MONITOR/CALL key or a handset, Redialing, Tel Mode

At the end of the operation, your fax machine will beep and display:

Sending a fax using MONITOR/CALL key or a handset

You also can fax a document using either the monitor speaker or the optional handset to dial the call.

1 Insert the document to the ADF. If necessary, adjust document mode and con- trast.

2 Obtain a dial tone, either by:

•Pressing MONITOR/CALL

… or …

•Lifting the optional handset. In either case, the LCD shows:

**Tel Mode **

_

3 Enter the fax number by using the numeric keypad.

Also, enter access codes with the number, just as for a regular phone call.

** Tel Mode ** 919725552009_

4 When you hear fax tones from the remote unit, press START.

Note: If a person answers the phone, use the optional handset to tell that person that you’re trying to send a fax. When you hear fax tones, press START.

5 If you’re using an optional handset, hang up after pressing START.

6

919725552009

** Complete **

Note: If the call fails and you used MONITOR/CALL to dial, press MONITOR/CALL to hang up. Or if you’ve pressed START to begin the fax transmission, press STOP to end it.

Also see “Redialing manually,” right column, if the call fails.

Basic operation

Redialing

Automatically fax redialing

If your fax call fails, your machine automatically redials it. In this Auto Redial mode, your fax automatically redials the number up to two times at one minute inter- vals.

Note: You can change the redial time and interval settings. (See “Changing redial settings,” page 4.5.)

While in the Auto Redial mode, “AutoRedial” appears on the first line of the LCD, and the machine can continue to receive faxes and can make as many as 99 fax trans- missions.

** Auto Redial **

Jan 27 2002 2:30pm

Note: If you used either the MONITOR/CALL key or a handset to dial the call, you must redial manually (see below).

Note: If the last redial attempt fails, your machine may print (and/or display) error messages.

Redialing manually

You can always redial calls manually. And you must redial manually if you used either the MONITOR/CALL key or an optional handset to dial the failed call.

To redial a fax call manually without using the MONITOR/CALL key or an optional handset:

1 Set the document and set the document mode and contrast.

2 Press (REDIAL). The LCD will show:

View Redial History 0:1234567890

3 Your machine can remember the last 10 dial numbers. Press or until the dial number you want to redial appears.

4 Press START.

2.5