Muratec F-320 manual Programming a batch transmission, Batch Tx $/#/Enter

Your display can show only 20 characters at a time. To view characters beyond those 20, press to scroll to the left or to scroll to the right.

If you want the polling to begin immediately every time you press the key, press ENTER and proceed to step 11.

If you want to delay the polling, follow steps 7–9 on page 3.33. Then press

ENTER, ENTER.

Press STOP to return your machine to standby mode.

11 Use the numeric keypad to enter the appropriate ITU-Tpassword for the box.

12 Press ENTER. The LCD shows:

58:Fax#/Comm.Options

_

13 Use the numeric keypad to enter the number exactly as your machine should dial it, including whatever codes your phone system requires. The number can be up to 40 characters in length.

Advanced features

8 Press ENTER. The LCD shows:

Enter Sub-Address

_

9 Use the numeric keypad to enter the ITU-Tsub-address for the box from which you want to poll the document.

10 Press ENTER. The LCD shows:

Enter Password

_

Note: If there isn’t a password for this box, skip to step 12.

14

15

Programming a batch transmission

For this operation to work, two things must be true:

•The batch box you’re using must exist on your fax machine.

•You must know the batch box’s identifier number (1–5).

To program a batch transmission into a programmable one-touch key:

1 Press MENU, 3, 4, 1, ENTER. The LCD shows the first empty programmable one- touch number available:

Select Program No. 58:No Number Stored

2	Press		or	to select the programmable one-touch key in which you want to
	store or change.
	Note: You can select the one-touch key by pressing that key on the control
			panel.
3	If you selected the empty programmable one-touch key, proceed to step 4.
	If you selected the key already programmed and you want to change it, skip
	to step 6.
	Note: If your previous command for this key was a batch transmission and
			you want to keep this key programmed a batch transmission, use these
			instructions to make changes. But if the previous command for this
			key was a different command, you must first erase the stored com-
			mand (see page 3.41) before programming the new one.
4	Press ENTER. The LCD shows:
		Type :Communication
				$/#/Enter
5
	Press		or	until “Communication” appears.
6	Press ENTER. The LCD shows:
		58:Fax#/Comm.Options
		_
7
	Press COMM. OPTIONS five times. The LCD shows:
		5.Batch Tx
				$/#/Enter
8
	Press ENTER. The LCD shows:
		Batch Tx
		Enter Box No.			:_
9
	Use the numeric keypad to enter the one-digit identifier for the batch box you
	want.

Note: To change an identifier already entered, press CANCEL to erase it. Then re-enter the correct identifier.

3.38