Muratec F-320 manual Polling $/#/Enter, Code Tx $/#/Enter

Advanced features

4 Press ENTER. The LCD shows:

Type :Communication $/#/Enter

5 Press or until “Communication” appears.

6 Press ENTER. The LCD shows:

58:Fax#/Comm.Options

_

7 Press COMM. OPTIONS twice. The LCD shows:

2.Polling

$/#/Enter

8 Press ENTER. The LCD shows:

58:Fax#/Comm.Options

_

9 Use the numeric keypad to enter the number exactly as your machine should dial it, including whatever codes your phone system requires. The number can be up to 40 characters in length.

Your display can show only 20 characters at a time. To view characters beyond those 20, press to scroll to the left or to scroll to the right.

10 If you want the polling to begin immediately every time you press the key, press ENTER and proceed to step 11.

If you want to delay the polling, follow steps 7–9 on page 3.33. Then press

ENTER, ENTER.

11 Press STOP to return your machine to standby mode.

Programming an F-Code transmission

For this operation to work, two things must be true:

•You must know how the remote fax is using each F-Code box to which you’re transmitting — for example, as a security box or a relay box. Different fax manu- facturers may use slightly different terms, but the concepts are the same.

•You must know the remote fax’s ITU-Tsub-address and password for each box to which you want to transmit.

To program an F-Code transmission into a programmable one-touch key:

1 Press MENU, 3, 4, 1, ENTER. The LCD shows the first empty programmable one- touch number available:

Select Program No. 58:No Number Stored

2 Press or to select the programmable one-touch key in which you want to store or change.

Note: You can select the one-touch key by pressing that key on the control panel.

3 If you selected the empty programmable one-touch key, proceed to step 4. If you selected the key already programmed and you want to change it, skip to step 6.

Note: If your previous command for this key was a F-Code transmission and you want to keep this key programmed a F-Code transmission, use these instructions to make changes. But if the previous command for this key was a different command, you must first erase the stored com- mand (see page 3.41) before programming the new one.

4 Press ENTER. The LCD shows:

Type :Communication $/#/Enter

5 Press or until “Communication” appears.

6 Press ENTER. The LCD shows:

58:Fax#/Comm.Options

_

7 Press COMM. OPTIONS three times. The LCD shows:

3.F-Code Tx $/#/Enter

8 Press ENTER. The LCD shows:

Enter Sub-Address

_

9 Use the numeric keypad to enter the ITU-Tsub-address for the box to which you want to send the document.

3.36