Muratec F-320 manual Code Polling $/#/Enter, Programming F-Code polling

Use the numeric keypad to enter the appropriate ITU-Tpassword for the box.

10 Press ENTER. The LCD shows:

Enter Password

_

Note: If there isn’t a password for this box, skip to step 12.

11

12 Press ENTER. The LCD shows:

58:Fax#/Comm.Options

_

13 Use the numeric keypad to enter the number exactly as your machine should dial it, including whatever codes your phone system requires. The number can be up to 40 characters in length.

Your display can show only 20 characters at a time. To view characters beyond those 20, press to scroll to the left or to scroll to the right.

14 If you want the transmission to begin immediately every time you press the key, press ENTER and proceed to step 15.

If you want to delay the transmission, follow steps 7–9 on page 3.33. Then

press ENTER, ENTER.

15 The LCD now asks if you want to make additional settings for this program- mable one-touch number.

Option :Off $/#/Enter

If you do not want to make additional settings, select “Off” and press ENTER. Then skip to step 17.

If you do want to make additional settings, press to select “On” and press

ENTER.

16 Follow steps 13–25 on page 3.34.

17 Press STOP to return your machine to standby mode.

Advanced features

Programming F-Code polling

For this operation to work, two things must be true:

•The document which you’re polling must exist in the remote fax’s F-Code box (ITU-Tstandard sub-addressing/password box).

•You must know the remote fax’s ITU-Tsub-address and password (if any) for each box you want to poll.

To program an F-Code polling operating into a programmable one-touch key:

1 Press MENU, 3, 4, 1, ENTER. The LCD shows the first empty programmable one- touch number available:

Select Program No. 58:No Number Stored

2 Press or to select the programmable one-touch key in which you want to store or change.

Note: You can select the one-touch key by pressing that key on the control panel.

3 If you selected the empty programmable one-touch key, proceed to step 4. If you selected the key already programmed and you want to change it, skip to step 6.

Note: If your previous command for this key was a F-Code polling and you want to keep this key programmed a F-Code polling, use these instruc- tions to make changes. But if the previous command for this key was a different command, you must first erase the stored command (see page 3.41) before programming the new one.

4 Press ENTER. The LCD shows:

Type :Communication $/#/Enter

5 Press or until “Communication” appears.

6 Press ENTER. The LCD shows:

58:Fax#/Comm.Options

_

7 Press COMM. OPTIONS four times. The LCD shows:

4.F-Code Polling $/#/Enter

3.37