Muratec F-320 manual Tcp/Ip

Getting started

Level one function	Level two function	Level three function	Summary of setting	Default setting	Page
2. User Settings	2.Fax Settings	01.Scan Parameters	You can set the following settings for send fax message.
			• Primary document mode	Normal
			• Primary contrast mode	Normal	4.1
		02.Print Parameters	You can set the following settings for receive fax message.
			• Reduction rate	Auto
			• Reduction margin	40 mm	4.3
			• Half-page reception	Off
		03.Number of Rings	Number of rings before your machine answers.	2 times	4.4
		04.Redial	Number of times and interval for automatic fax redialing.	2 times	4.5
				1 minute
		05.Dialing Pause	Dialing pause length.	2 seconds	4.5
		06.Memory Tx	On/Off setting for Memory transmission.	On	4.2
		07.Quick Tx	On/Off setting for Quick Memory transmission.	On	4.2
		08.TTI Tx	On/Off setting for sending your TTI.	On	4.2
		09.ECM Mode	On/Off setting for ECM mode.	On	4.1
		10.Block Junk Fax	Reject the fax reception from unauthorized incoming faxes.	Off	3.45
		11.Security Rx	Keep all received fax messages in memory and after print them.	Off	3.42
		12.Separator Page	Partition each received documents by inserting the separator page.	Off	3.21
		13.PIN Mode	Prevent unauthorized long-distance calls.	Off	3.43
		14.DRD	Set the ring pattern to use with phone company’s Distinctive Ring	Off	3.22
			service.
	3.Copy Settings	1.Scan Parameters	You can set the following settings for copying.
			• Primary document mode	Fine	4.6
			• Primary contrast mode	Normal
		2.Print Parameters	You can set the following settings for copying.
			• Reduction rate	100%	4.7
			• Reduction margin	24 mm
			• Bypass Tray priority	Off
	4.Printer Settings*3	1.TCP/IP	Enter the IP Address, Subnet mask and Gate way address.	—	—
	5.Scanner Settings*4	1.Scan Parameters	Enter the scanning parameters.	—	—
		2.Auto Reset	Set the time (minutes) for resetting the scan parameters and .	3 minutes	—
			returning to the Fax mode.
*3: This option appears only if the optional NIC (network interface card) has been installed.
*4: This option appears only if the optional printer controller has been installed. For details see the operating instructions included with the printer controller kit.

1.14