NEC 750176-1 manual Message delivery telephone numbers

EliteMail VMS/EliteMail Limited Issue 1

Message Notification

If you are looking at the Expanded Transfer Options on the subscriber Personal Directory page, press ￿￿%#￿to close it. The system displays the Message Notification part of the screen. This is where you set up message notification and delivery settings for the subscriber.

Lamp #

Enter the area code and number the voice mail system should dial to turn￿￿￿￿￿￿￿￿a message waiting lamp on or off for the subscriber, and press

￿. Use X for the subscriber extension number. Activate Lamps?

1.Enter Y, and press ￿￿￿￿￿￿￿￿to indicate if the voice mail system should activate message waiting lamps.

2.If you select Y, also check the Message Lamp On and Off codes at the top of Switch Setup Screen Page 2 to verify that they are the correct codes for your telephone system. These codes were configured automatically when you selected your NEC telephone system. (Refer to Section 2 Program Worksheet 1: Site Information on page 3-2.)

3.Enter N, and press ￿￿￿￿￿￿￿￿to indicate if the voice mail system should not activate message waiting lamps.

Message delivery telephone numbers

Fill in the specifics for each message delivery telephone number on the last 4 lines of the Message Notification screen. For each telephone number you want the voice mail system to call to deliver messages, fill in the following:

For details about the special characters you can use in message delivery telephone numbers, refer to the EliteMail VMS/EliteMail Limited Technician Guide. These characters allow you to program pauses and other special

￿dialing for your NEC telephone system.

#1

Enter the telephone number (or X) you want the system to dial, and

press ￿￿￿￿￿￿￿￿.

Job Specifications Manual 3 - 43