User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Format

show port {<slot/port> all}

Mode

Privileged EXEC

Slot/Port

Valid slot and port number separated by forward slashes.

Type

If not blank, this field indicates that this port is a special type of

 

port. The possible values are:

 

Mon - this port is a monitoring port. Look at the Port Monitoring

 

screens to find out more information.

 

Lag - this port is a member of a port-channel (LAG).

 

Probe - this port is a probe port.

Admin Mode

Selects the Port control administration state. The port must be

 

enabled in order for it to be allowed into the network. - May be

 

enabled or disabled. The factory default is enabled.

Physical Mode

Selects the desired port speed and duplex mode. If auto-negotia-

 

tion support is selected, then the duplex mode and speed will be

 

set from the auto-negotiation process. Note that the port's maxi-

 

mum capability (full duplex -100M) will be advertised. Other-

 

wise, this object will determine the port's duplex mode and

 

transmission rate. The factory default is Auto.

Physical Status

Indicates the port speed and duplex mode.

Link Status

Indicates whether the Link is up or down.

Link Trap

This object determines whether or not to send a trap when link

 

status changes. The factory default is enabled.

LACP Mode

Displays whether LACP is enabled or disabled on this port.

show port protocol

This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated Group.

Format

show port protocol <groupid all>

Mode

Privileged EXEC

Group Name

This field displays the group name of an entry in the Protocol-based VLAN

 

table.

Group ID

This field displays the group identifier of the protocol group.

Protocol(s)

This field indicates the type of protocol(s) for this group.

 

 

Switching Commands

8-47

202-10088-01, March 2005

Page 117
Image 117
NETGEAR 7300S manual Show port protocol