User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-28 Switching Commands
202-10088-01, March 2005
Access Mode The access level for this community string.
Status The status of this community access entry.
show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an
SNMP Network Manager. These messages alert the manager to events occurring within the switch
or on the network. Six trap receivers are simultaneously supported.
Format show snmptrap
Mode Privileged EXEC
SNMP Trap Name The community string of the SNMP trap packet sent to the trap
manager. This may be up to 16 alphanumeric characters. This
string is case sensitive.
IP Address The IP address to receive SNMP traps from this device. Enter
four numbers between 0 and 255 separated by periods.
Status A pull down menu that indicates the receiver's status (enabled or
disabled) and allows the administrator/user to perform actions on
this user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
show trapflags
This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected,
the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to
be reset to implement the changes. Cold and warm start traps are always generated and cannot be
disabled.
Format show trapflags
Mode Privileged EXEC
Authentication Flag May be enabled or disabled. The factory default is enabled. Indi-
cates whether authentication failure traps will be sent.
Link Up/Down Flag May be enabled or disabled. The factory default is enabled. Indi-
cates whether link status traps will be sent.