NETGEAR 7300S manual System Utility Commands, Traceroute, Ingress Filtering

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

	port. With either option, VLAN tagged frames are forwarded in
	accordance to the 802.1Q VLAN specification.
Ingress Filtering	May be enabled or disabled. When enabled, the frame is dis-
	carded if this port is not a member of the VLAN with which this
	frame is associated. In a tagged frame, the VLAN is identified by
	the VLAN ID in the tag. In an untagged frame, the VLAN is the
	Port VLAN ID specified for the port that received this frame.
	When disabled, all frames are forwarded in accordance with the
	802.1Q VLAN bridge specification. The factory default is dis-
	abled.
GVRP	May be enabled or disabled.

Default Priority The 802.1p priority assigned to tagged packets arriving on the port.

System Utility Commands

This section describes system utilities. The commands are divided into two functional groups:

•Show commands display switch settings, statistics, and other information.

•Configuration commands configure features and options of the switch. For every configuration command, there is a show command that displays the configuration setting.

traceroute

This command is used to discover the routes that packets actually take when traveling to their destination through the network on a hop-by-hop basis. <ipaddr> should be a valid IP address. [port] should be a valid decimal integer in the range of 0(zero) to 65535. The default value is 33434.

The optional port parameter is the UDP port used as the destination of packets sent as part of the traceroute. This port should be an unused port on the destination system.

Format	traceroute <ipaddr> [port]
Mode	Privileged EXEC

Switching Commands 8-59

202-10088-01, March 2005