NETGEAR 7300S manual Set igmp groupmembership-interval, No set igmp

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

no set igmp

This command disables IGMP Snooping on the system.

Format	no set	igmp
Mode	Global	Config

set igmp

This command enables IGMP Snooping on a selected interface. If an interface which has IGMP Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG), IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed from an interface that has IGMP Snooping enabled.

Default	disabled
Format	set igmp
Mode	Interface Config
no set igmp

This command disables IGMP Snooping on a selected interface.

Format	no set igmp
Mode	Interface Config

set igmp groupmembership-interval

This command sets the IGMP Group Membership Interval time on the system. The Group Membership Interval time is the amount of time in seconds that a switch waits for a report from a particular group on a particular interface before deleting the interface from the entry. This value must be greater than the IGMP Maximum Response time value. The range is 2 to 3600 seconds.

Default	260
Format	set igmp groupmembership-interval <2-3600>
Mode	Global Config

no set igmp groupmembership-interval

This command sets the IGMP Group Membership Interval time on the system to 260 seconds.

8-106 Switching Commands

202-10088-01, March 2005