User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
11-40 Quality of Service (QoS) Commands
202-10088-01, March 2005
Policy Name The name of the policy attached to the interface.
Note: None of the counters listed here are guaranteed to be supported
on all platforms. Only supported counters are shown in the dis-
play output.
Class of Service (CoS) Commands
This chapter provides a detailed explanation of the software QoS CoS commands. The following
commands are available in the software QOS module.
The commands are divided into these different groups:
• Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
• Show commands are used to display device settings, statistics and other information.
Note: The 'Interface Config' mode only affects a single interface, whereas the 'Global Config'
mode is applied to all interfaces.

classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class. The userpriority and
trafficclass can both range from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format classofservice dot1p-mapping <userpriority> <traffic-
class>
Modes Global Config
Interface Config

classofservice ip-dscp-mapping

This command maps an IP DSCP value to an internal traffic class. The ipdscp range is from 0-63
and the trafficclass range is from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format classofservice ip-dscp-mapping <ipdscp> <traffic-
class>