User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-111
202-10088-01, March 2005
Format set igmp maxresponse <vlanId> <1-3599>
Mode Vlan Mode
no set igmp maxresponse
This command sets the IGMP Maximum Response time on the VLAN to the default value.
Format no set igmp maxresponse <vlanId>
Mode Vlan Mode
set igmp mcrtexpiretime
This command sets the Multicast Router Present Expiration time on a particular VLAN. This is the
amount of time in seconds that a switch will wait for a query to be received on an interface, which
is participating in the VLAN, before the interface is removed from the list of interfaces with
multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-
out, i.e. no expiration.
Default 0
Format set igmp mcrtexpiretime <vlanId> <0-3600>
Mode Vlan Mode
no set igmp mcrtexpiretime
This command sets the Multicast Router Present Expiration time on the VLAN to 0. A value of 0
indicates an infinite time-out, i.e. no expiration.
Format no set igmp mcrtexpiretime <vlanId>
Mode Vlan Mode
set igmp fast-leave
This command enables or disables IGMP Snooping fast-leave admin mode on a selected VLAN.
Enabling fast-leave allows the switch to immediately remove the layer 2 LAN interface,
participating in the VLAN, from its forwarding table entry upon receiving an IGMP leave message
for that multicast group without first sending out MAC-based general queries to the interface.