NETGEAR 7300S manual Expedite kbps, Expedite percent

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

no class

This command deletes the instance of a particular class and its defined treatment from the specified policy. <classname> is the names of an existing DiffServ class. Note that this command removes the reference to the class definition for the specified policy.

Format	no class <classname>
Mode	Policy-Map Config
expedite kbps

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the specified class instance within the named policy using an absolute rate notation. The committed information rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The optional committed burst size is specified in kilobytes (KB) as an integer from 1 to 128, with a default of 4.

Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.

Note: The expedite kbps and percent commands are alternative ways to specify the same expedite policy attribute.

Format	expedite kbps <1-4294967295> [1-128]
Mode	Policy-classmap Config
Restrictions	The sum of the committed information rate values for all band-
	width and expedite commands defined within a policy must not
	exceed the available link bandwidth of the interface to which that
	policy is assigned. Violation of this requirement shall prevent
	successful attachment of a policy to the interface, or shall cause
	this command to fail if the policy is already in service on one or
	more interfaces.
Policy Type	Out
Incompatibilities	Bandwidth (all forms), Shape Peak
expedite percent

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the specified class instance within the named policy using a relative rate notation. The committed information rate is specified as a percentage of total link capacity and is an integer from 1 to 100. The optional committed burst size is specified in kilobytes (KB) as an integer from 1 to 128, with a default of 4.

11-22 Quality of Service (QoS) Commands

202-10088-01, March 2005