NETGEAR 7300S manual Figuration mode to configure the QoS policy map

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

	In this mode, a physical port is set up for a specific logical con-
	nection operation. The Interface Config mode provides access to
	the router interface configuration commands. The command
	prompt at this level is:
	Command Prompt: $(Interface <slot/port>)#
	The resulting prompt for the interface configuration command
	entered in the Global Configuration mode is shown below:
	$(Config)# interface 2/1
	$(Interface 2/1)#
Line Config Mode	This mode allows the operator to configure the console interface.
	The operator may configure the interface from the directly con-
	nected console or the virtual terminal used with Telnet. The com-
	mand prompt at this level is:
	Command Prompt: $(Line)#
Policy Map Mode	Use the policy-map command to access the QoS policy map con-
	figuration mode to configure the QoS policy map.
	$(Config)# policy-map
	Command Prompt: $(Config policy-map)#
Policy Class Mode	Use the "class" command to access the QoS policy- classmap
	mode to configure the QoS policy map.
	$(Config-policy-map)# class
	Command Prompt: $(Config - policy-classmap)#
Class Map Mode	This mode consists of class creation/deletion and matching com-
	mands. The class match commands specify layer 2, layer 3 and
	general match criteria. Use the class-map commands to access the
	QoS class map configuration mode to configure QoS class maps.
	$(Config)# class map
	Command Prompt: $(Config - class)#
Router Config RIP Mode	In this mode, the operator is allowed to access the router RIP con-
	figuration commands. The command prompt at this level is:
	$(Config)# router rip

Command Prompt: $(Config-router)#

DHCP Pool Configuration Mode Use the ip dhcp pool <pool-name> command to access the DHCP Pool Config Mode.

$(Config)# ip dhcp pool <pool-name> Command Prompt: (Config-dhcp-pool)#

Mode-based CLI 7-5

202-10088-01, March 2005