NETGEAR 7300S manual Redirect, Conform-color, Bandwidth kbps, Policy Type

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

redirect

This command specifies that all incoming packets for the associated traffic stream are redirected to a specific egress interface (physical port or port-channel).

Format	redirect <slot/port>
Mode	Policy-Class-Map Config
conform-color

This command is used to enable color-aware traffic policing and define the conform-color and exceed-color class maps used. Used in conjunction with the police command where the fields for the conform level (for simple, single-rate, and two-rate policing) and optionally the exceed level (for single-rate and two-rate policing) are specified. The <class-map-name> parameter is the name of an existing Diffserv class map, where different ones must be used for the conform and exceed colors.

Format	conform-color <class-map-name> [exceed-color <class-
	map-name>]
Mode	Policy-Class-Map Config
bandwidth kbps

This command identifies a minimum amount of bandwidth to be reserved for the specified class instance within the named policy using an absolute rate notation. The committed information rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295.

Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.

Note: The bandwidth kbps and percent commands are alternative ways to specify the same bandwidth policy attribute.

Format	bandwidth kbps <1-4294967295>
Mode	Policy-classmap Config
Restrictions	The sum of the committed information rate values for all band-
	width and expedite commands defined within a policy must not
	exceed the available link bandwidth of the interface to which that
	policy is assigned. Violation of this requirement shall prevent
	successful attachment of a policy to the interface, or shall cause
	this command to fail if the policy is already in service on one or
	more interfaces.
Policy Type	Out
11-20	Quality of Service (QoS) Commands

202-10088-01, March 2005