User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

encapsulation

This command configures the link layer encapsulation type for the packet. Acceptable values for <encapstype> are Ethernet and SNAP. The default is Ethernet.

Format

encapsulation {ethernet snap}

Mode

Interface Config

Restrictions

Routed frames are always Ethernet encapsulated when a frame is

 

routed to a VLAN.

Bootp/DHCP Relay Commands

This chapter provides a detailed explanation of the BootP/DHCP Relay commands. The commands are divided by functionality into the following different groups:

Show commands are used to display switch settings, statistics and other information.

Configuration Commands are used to configure features and options of the switch. For every configuration command there is a show command that will display the configuration setting.

Copy commands are used to transfer configuration and informational files to and from the switch.

bootpdhcprelay cidoptmode

This command enables the circuit ID option mode for BootP/DHCP Relay on the system.

Default

disabled

Format

bootpdhcprelay cidoptmode

Mode

Global Config

no bootpdhcprelay cidoptmode

This command disables the circuit ID option mode for BootP/DHCP Relay on the system.

Format

no bootpdhcprelay cidoptmode

Mode

Global Config

Routing Commands

10-15

202-10088-01, March 2005

Page 249
Image 249
NETGEAR 7300S manual Bootp/DHCP Relay Commands, Encapsulation, Bootpdhcprelay cidoptmode, Restrictions