User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Chapter 11

Quality of Service (QoS) Commands

This chapter provides a detailed explanation of the Quality of Service (QOS) commands. The following QOS commands are available in the software QOS module.

The commands are divided into these different groups:

Show commands are used to display device settings, statistics and other information.

Configuration Commands are used to configure features and options of the switch. For every configuration command there is a show command that will display the configuration setting.

Access Control List (ACL) Commands

Access Control Lists (ACLs) ensure that only authorized users have access to specific resources while blocking off any unwarranted attempts to reach network resources.

Note:

ACL configuration for IP packet fragments is not supported.

The maximum number of rules per ACL translates into the number of hardware classifier entries used when an ACL is attached to an interface. Increasing these values in the software increases the RAM and NVSTORE usage.

ACLs are configured separately for Layer 2 and Layer 3/Layer 4. Some types of hardware do not allow both types of ACLs to be applied to the same interface.

mac access-list extended <name>

This command creates a MAC Access Control List (ACL) identified by <name>, consisting of classification fields defined for the Layer 2 header of an Ethernet frame. The <name> parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list.

If a MAC ACL by this name already exists, this command enters Mac-Access-List config mode to allow updating the existing ACL.

Quality of Service (QoS) Commands

11-1

202-10088-01, March 2005

Page 265
Image 265
NETGEAR 7300S manual Access Control List ACL Commands, Mac access-list extended name