Chapter 5 Analog Modules | SMART I/O User’s Manual | |||
|
|
|
|
|
|
|
|
|
|
5.3.9 ISaGRAF Programming
5.3.9.1 The ISaGRAF Board Parameters
Information on board parameters may be found in the PEP online help and ISaGRAF online help or user’s manual.
Figure 5.3.9.1.1 a Typical Screen Section for the SM-THERM Module
Logical Address
The 4 inputs of this module may be clearly seen together with the logical address at which this particular board is residing. Remember, this logical address is the same as the physical slot position! In the example shown here, the board being addressed is in slot 3 i.e. the third of the
Module Specific Information
5
calib_period :
type_ch(x) :
This is the time in seconds for cyclic calibration if required. An entry of zero disables the function. This parameter is set depending on the sensor type or may be ‘V’ if the measured values are required in microvolts with a module in bipolar mode.
|
|
|
|
March 12, 1996 | ©1996 PEP Modular Computers GmbH | Page 5 - 85 | |
|
| ||
