SMART I/O User’s Manual | Chapter 5 Analog Modules | |||
|
|
|
|
|
|
|
|
|
|
5.2.9 ISaGRAF Programming
5.2.9.1 The ISaGRAF Board Parameters
Information on board parameters may be found in the PEP online help and ISaGRAF online help or user’s manual.
Figure 5.2.9.1.1 a Typical Screen Section for the SM-PT100 Module
Logical Address
The 4 inputs of this module may be clearly seen together with the logical address at which this particular board is residing. Remember, this logical address is the same as the physical slot position! In the example shown here, the board being addressed is in slot 3 i.e. the third of the
Module Specific Information :
calib_period :
type_ch(x) :
This is the time in seconds for cyclic calibration if required. An entry of zero disables the function. This parameter is either resistor100 or PT100 depending whether the returned value should be raw ohmic or calibrated in degrees Celsius respectively.
|
|
|
|
Page | 5 - 56 | ©1996 PEP Modular Computers GmbH | March 12, 1996 |
|
|
|
