SMART I/O User’s Manual | Chapter 6 Communications Modules | |||
|
|
|
|
|
|
|
|
|
|
6.2.13 ISaGRAF Programming
6.2.13.1 The ISaGRAF Board Parameters
Because this module has not been defined as a physical board in the ISaGRAF project, it has been created as a function block as shown in figure 6.2.13.1.1.
Figure 6.2.13.1.1 Function block of the SM-SSI Module
Command
One of:
FB_SSI_INIT
FB_SSI_SETPOINT
This is the command that must be executed to initialize the module before operating the SSI interface - normally at the beginning of an ISaGRAF program cycle. Also, prior to using this call, if the ctrlx variables have been defined with a value, then these will be sent to the
This gives the user the possibility to enter a value for the comparator register when testing for a match between the actual
|
|
|
|
Page | 6- 36 | ©1996 PEP Modular Computers GmbH | October 01, 1996 |
|
|
|