SMART I/O User’s Manual | Introduction | |||
|
|
|
|
|
|
|
|
|
|
In order to verify that the hardware and software have been correctly setup, the following procedure should be followed.
•Connect the
•With the power supply turned OFF, connect the power plug to
•Start the
•Switch on the power supply to the SMART I/O; three green LEDs should illuminate on the control panel (not the SMART Modules!). The terminal should display the messages shown in figure 1.5.3.2.
Figure 1.5.3.2 Power Up Messages
|
|
|
|
Page | 1 - 24 | ©1996 PEP Modular Computers GmbH | March 12, 1996 |
|
|
|