Sanyo DSR-5009P instruction manual Setting the motion sensors, Level

2RECORD SET

5 Turn the jog dial to select an alarm detection method and then turn the shuttle dial clockwise.

The cursor moves to “MOTION SENSOR”.

		<ALARM REC MODE SET>
		ALARM RECORDING	: ENABLED
		PICTURE QUALITY	: ENHANCED
		PICTURE QUALITY SET	->
		AUDIO RECORDING	: OFF
		ALARM INTERLEAVE	: ONLY
		REC RATE: 12.5FPS, DURATION: 20SEC
		PRE-ALARM RECORDING	: OFF
		REC RATE: ***** FPS,	DURATION: *****
		ALARM TRIGGER	: ALARM
		MOTION SENSOR	->
[Settings] (‹ indicates default setting)
Setting		Description
‹ALARM	Alarm recording is performed when
	an external alarm*1 occurs.
	Alarm recording is performed when
SENSOR	a motion sensor detects movement.
	(JP.99)
	Alarm recording is performed when
ALARM AND SENSOR	both the external alarm*1 and a
	motion sensor are activated
	simultaneously.
	Alarm recording is performed when
ALARM OR SENSOR	either the external alarm*1 or a
	motion sensor is activated.

*1 External alarm

zSwitch is attached to the ALARM IN terminal on the rear panel and alarm is detected by opening and closing the switch.

zCoaxial alarm signals from a coaxial superimposition camera

[Setting conditions]

zWhen “SENSOR”, “ALARM AND SENSOR” or “ALARM OR SENSOR” is selected, the motion sensors must be set.

6 Press the [EXIT/OSD] button.

The setting is completed and the display returns to the normal screen.

EXIT/OSD

Setting the motion sensors

Use the following procedure to set motion sensors on video from each camera so that alarms can be detected.

(1)

(2)CH01 T-1 LEVEL : OFF MODE : A

(3)(4) (5)

(1)Motion sensor setting

Display changes in response to the sensor condition. Settings are made using the jog dial.

-: Sensor off

A or B: Sensor on

(2) Camera number display

Changes when a [CAMERA SELECT] button is pressed. Use this item to select the camera for which motion sensors are to be set up.

(3) Time period

Select an interval set using “TIME PERIOD” (JP.69).

(4) LEVEL

Sets the sensitivity level of the motion sensors. OFF: No motion sensor has been set.

1 to 10: A motion sensor is set. Lower values correspond to higher sensitivity levels and vice versa.

(5) MODE

Sets the detection method for the motion sensors. (JP.102)

1 Make timer settings for “TIME PERIOD A” and “TIME PERIOD B” on the <TIME PERIOD SET> screen. (JP.69)

2 Press the [MENU] button.

The MENU indicator lights up and the <MAIN MENU> is displayed.

MENU

English 99