Sanyo DSR-5009P instruction manual 173, Searching for Recorded Video Motion Detection Search

3SEARCHING FOR RECORDED VIDEO

6. MOTION DETECTION SEARCH

Use the following procedure to detect variations from recorded images, using the motion sensor, as a result of the presence of an intruder or the like, and to play back the corresponding images.

1 Click “6. MOTION DETECTION SEARCH” on the “SEARCH” screen.

The “MOTION DETECTION SEARCH” screen is displayed.

2 Specify the search area from the “SEARCH FROM” pull-down menu.

(1)

(4) (6)

MOTION DETECTION SEARCH

SEARCH FROM : ALARM

[Settings] (‹ indicates default setting)

Setting	Description
‹ALARM	Searches only for alarm recording
	images.

(2)CHANNEL : --

(3)	START			:	01	-	01	-	2005	00		:	40
		END		:
														SET
					01	-	09	-	2005	12		:	40
(5)
			FOUND !								MOTION SENSOR SET

	A B C D E F G H I J A B C D E F G H I J
1	1	1
2	2	2
3	3	3
4	4	4
5	5	5
6	6	6
7	7	7
8	8	8
	A B C D E F G H I J A B C D E F G H I J
	MOTION SENSOR LEVEL: OFF	PREVIEW

PLEASE CLICK THE IMAGE TO PLAY.

(7) (8)

(1) SEARCH FROM

Recording area to be used for motion detection searching

(2) CHANNEL

Channel or camera number to be used for motion detection searching

(3) START/END

Date and time of the start and end of the area for motion detection searching

(4)[SET] button Detection condition settings

(5)Message box

Displays the results of searching for motion detection images.

When searching	“SEARCHING”
When motion-detection	“FOUND !”
images exist
When motion-detection	“IMAGES NOT FOUND !”
images do not exist

(6) MOTION SENSOR SET

Screen for making motion sensor settings

(7) MOTION SENSOR LEVEL

Motion sensor sensitivity setting: OFF or 1 through 10 (Lower numbers correspond to higher levels of sensitivity.)

(8) [PREVIEW] button

Displays a preview of the motion detection image.

NORMAL	Searches only for normal
	recording images.
ALARM AND NORMAL	Searches for alarm recording and
	normal recording images.
ARCHIVE*1	Searches only for archive images.

*1 “ARCHIVE” can only be selected when “MODE” in “ARCHIVE AREA” in the <RECORDING CONDITIONS SET> screen is set to “AUTO ALARM COPY”. (JP.81)

3 Specify the camera number for detection from the “CHANNEL” pull- down menu.

4 Click [SET].

The date and time of the start and end of recording of motion detection images are displayed in “START” and “END” respectively.

zUse “START” and “END” to refine the search range by making date and time settings.

zThe search results are displayed in a message box when [SET] is clicked.

5 Set motion sensor detection conditions.

zMotion sensor positions

The motion sensor setting screen displays an 8 x 10 (height x width) grid of sensors. When one of these sensors is clicked, the corresponding sensor setting mark changes to red. If the same location in the grid is clicked again, the motion sensor is deselected.

zMotion sensor sensitivity

Select the sensitivity from the pull-down menu. Lower numbers correspond to higher levels of sensitivity.

6 Click [PREVIEW].

A search is performed within the specified area for images in which the motion sensor detected motion, and these images are then listed in recording order on the preview screen.

7 Click the preview screen to play back the image.

Full-screen playback starts.

English 173