Sanyo DSR-5009P instruction manual To set pre-alarm recording, Cursor moves to PRE-ALARM Recording

2RECORD SET

15 Turn the jog dial to select the “DURATION” setting and then turn the shuttle dial clockwise.

The cursor moves to “PRE-ALARM RECORDING”.

		<ALARM REC MODE SET>
		ALARM RECORDING	: ENABLED
		PICTURE QUALITY	: ENHANCED
		PICTURE QUALITY SET	->
		AUDIO RECORDING	: ON
		ALARM INTERLEAVE	: ONLY
		REC RATE:A12.5FPS, DURATION: 20SEC
		PRE-ALARM RECORDING	: OFF
		REC RATE: ***** FPS,	DURATION: *****
		ALARM TRIGGER	: ALARM
		MOTION SENSOR	->
[Settings] (‹ indicates default setting)
Setting		Description
5SEC, 10SEC, ‹20SEC,	Records for the set duration for
40SEC, 1MIN, 2MIN, 3MIN,
	each alarm.
4MIN, 5MIN, 10MIN, 15MIN
	Records while an alarm is
	activated.
CC	Recording continues for five
	seconds even if entry is less than
	five seconds.

16 Press the [EXIT/OSD] button.

The setting is completed and the display returns to the normal screen.

“ALARM” appears in the operation display.

When an alarm occurs, the number of alarms is displayed.

To set pre-alarm recording

Use the following procedure to set the recording rate and time.

zSettings cannot be made for “PRE-ALARM RECORDING” when “ALARM REC” is set to “OFF”.

1 Press the [MENU] button.

The MENU indicator lights up and the <MAIN MENU> is displayed.

MENU

2 Turn the jog dial to select “2.RECORD SET” and then turn the shuttle dial clockwise.

3 Turn the jog dial to select “7.ALARM REC MODE SET” and then turn the shuttle dial clockwise.

SETTINGS

EXIT/OSD

Number of alarms “ALARM” display

01-01-05 00:00:00 REC REPEAT EN A ALARM 0000001

02

The <ALARM REC MODE SET> screen is displayed.

<ALARM REC MODE	SET>
ALARM RECORDING	: ENABLED
PICTURE QUALITY	: ENHANCED
PICTURE QUALITY SET	->
AUDIO RECORDING	: OFF
ALARM INTERLEAVE	: ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING	: OFF
REC RATE: ***** FPS,	DURATION: *****
ALARM TRIGGER	: ALARM
MOTION SENSOR	->

zIf a new alarm from a different channel occurs during alarm recording, the alarm number in the top-right corner is incremented as if two alarms occurred. However, in cases where alarms occur consecutively on the same channel, alarm retrigger settings (JP.98) can be used to ensure that these are counted as only one alarm.

4 Turn the jog dial to select “PRE-ALARM RECORDING” and then turn the shuttle dial clockwise.

“OFF” flashes.

<ALARM REC MODE	SET>
ALARM RECORDING	: ENABLED
PICTURE QUALITY	: ENHANCED
PICTURE QUALITY SET	->
AUDIO RECORDING	: OFF
ALARM INTERLEAVE	: ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING	: OFF
REC RATE: ***** FPS,	DURATION: *****
ALARM TRIGGER	: ALARM
MOTION SENSOR	->

96 English