3RECORDING

FULL indicator

[REC/STOP] button

[TIMER] button

Normal recording

Use the following procedure to record monitored video.

zBe sure to set the time when using the digital video recorder for the first time. Recording is not possible until the time is set. (JP.20)

1 Press the [REC/STOP] button.

The REC/STOP indicator lights up, “REC” (i.e., the recording symbol) appears in the operation display and recording starts.

Recording symbol

REC/STOP

01-01-05 00:00:00 REC REPEAT EN A

02

zWhen recording for the first time, the default settings are used. (JP.83)

zWhen “OVERWRITE” on the <RECORDING CONDITIONS SET> screen is set to “OFF” and the space remaining in the recording area becomes insufficient, the FULL indicator begins to flash. If recording is continued beyond this point, the recording area becomes full and recording stops. Perform AREA FULL RESET to enable recording. (JP.79)

zPlayback is possible even while recording. (JP.18)

2 Press and hold the [REC/STOP] button for approximately 3 seconds to end normal recording.

“REC” disappears from the operation display and recording ends.

REC/STOP

Timer recording

Use the following procedure to record monitored video for a preset length of time.

zBe sure to set the time when using the digital video recorder for the first time. Recording is not possible until the time is set. (JP.20)

1 Set timer recording. (JP.87)

2 Press the [TIMER] button.

The TIMER indicator lights up and the digital video recorder enters timer recording standby mode.

TIMER

01-01-05 00:00:00

EN A

 

02

zAt the time specified for the start of timer recording, the REC/STOP indicator lights up, “REC” (i.e., the recording symbol) appears in the operation display and recording starts.

zAt the time specified for the end of timer recording, the REC/STOP indicator turns off and recording ends. The TIMER indicator remains lit. If the [TIMER] button is pressed, the TIMER indicator turns off.

zWhen “OVERWRITE” on the <RECORDING CONDITIONS SET> screen is set to “OFF” and the space remaining in the recording area becomes insufficient, the FULL indicator begins to flash. If recording is continued beyond this point, the recording area becomes full and recording stops. Perform AREA FULL RESET to enable recording. (JP.79)

zPlayback is possible even while recording.

3 Press the [TIMER] button to end timer recording before the end time.

The TIMER indicator turns off and recording ends.

TIMER

English

29

Page 30
Image 30
Sanyo DSR-5009P instruction manual Recording, Normal recording, Timer recording, Press the REC/STOP button