Sensor Alarm OUT terminals, Control terminals

12.SENSOR ALARM OUT terminals

The terminals are used when motion sensors have been set (JP.99) to output an alarm signal to a connected device upon detection of motion.

The DSR-5009P has nine terminals.

Pin	Signal	INTRODUCTION
Pin	Signal
2ND RS485/422 A	Control terminal (A)
2ND RS485/422 B	Control terminal (B)
C	Ground
REMOTE R1	Remote input 1
REMOTE R2	Remote input 2
CLOCK IN	Clock adjust input terminal
CLOCK OUT	Clock adjust output terminal
EXT TIMER IN	External timer input terminal
ALARM OUT	Alarm output terminal
ALARM RESET	Cancels alarm
NON REC OUT	Non-recording output
WARNING OUT	HDD or FAN error warning output
FULL	Capacity warning output for
FULL	recording area
	recording area
ARCHIVE FULL	Capacity warning output for archive
ARCHIVE FULL	area
	area
C	Ground

When the [ALL RESET] button is pressed, the digital video recorder is reset and the time is returned to its default setting.

Used to expand the hard disk. Cannot be used together with RAID unit.

Please contact the dealer for details. When handling and connecting, be sure to read the instruction manual included wtih the external storage unit.

Connects to a recordable CD or DVD drive. For compatibility, refer to the SANYO homepage. http://www.sanyosecurity.com/

The rear panel and front panel USB terminals cannot be connected to simultaneously.

17.LAN terminal (10BASE-T/100BASE-TX) Connect to switching hubs, routers and PCs.

18.RS-485 termination switch

Used when connecting multiple devices from the RS-485 control connectors.

19.RS-485 control connectors (A) (B) Connects to a system controller or dome cameras.

20.RS-232C terminal

Connects to a modem.

Insert the supplied power cord securely into this socket.

Secure the power card to the holder using the power cord tie (accessory) as shown in the illustration.

English