3INSTALLATION AND CONNECTIONS

Connecting a LAN terminal

Connect to a PC for control of the digital video recorder over a network with a switch or connect to the Internet.

LAN connection

To enable control of the digital video recorder over a network, connect to the switch via Ethernet cable or make a similar connection.

Use a straight type Ethernet cable.

PC

LAN

Ethernet cable (straight type cable)

Switch

Internet connection

Connect to the Internet via a router or similar device. When connecting to a router, use a straight type Ethernet cable.

To connect to an ADSL modem and other devices, be sure to read the instruction manuals for each connected device.

LAN

Internet

 

Ethernet cable (straight type cable)

Router, ADSL modem, etc.

Connecting an amplifier

Connect an amplifier to use a microphone or external speakers with the digital video recorder. AUDIO 1 IN terminal and AUDIO 2 IN terminal can be used together to record and play back audio from two locations.

Audio input

 

terminal

 

Audio

Amplifier

output terminal

(sold separately)

 

1-AUDIO-2 AUDIO OUT IN

zThe input audio channel connected to the AUDIO IN terminal on the rear panel can be switched with the [AUDIO] button. Each time this button is pressed, the channel changes in the following order: 1+2, OFF, 1, 2.

Connecting alarm input terminals

When using external alarms (i.e., intruder sensors), connect external switches to the ALARM IN terminals.

16

 

 

Connect external

 

switches to ALARM IN

1

terminals.

*

Only terminals 1 to 9 are available on the DSR-5009P.

*Wrap the Alarm input cable and the Sensor alarm output cable once around the core clamp (large) before attaching it.

INTRODUCTION

16

English

Page 17
Image 17
Sanyo DSR-5009P Connecting a LAN terminal, Connecting an amplifier, Connecting alarm input terminals, LAN connection