Sanyo DSR-5009P instruction manual Setting alarm triggers, Number of alarms, PRE display

2RECORD SET

9 Press the [EXIT/OSD] button.

The setting is completed and the display returns to the normal screen.

“PRE” appears in the operation display. When an alarm occurs, “ALARM” is displayed.

EXIT/OSD		Number of alarms
	“PRE” display
		01-01-05 00:00:00 REC REPEAT EN A PRE 0000000

02

zPre-alarm recording is performed during the period set by “DURATION” before an alarm occurs. To play back pre- alarm recordings, perform alarm search (using the [SEARCH] button). (JP.37)

Recordings are played back at the point the alarm occurs. Use the shuttle dial to begin reverse playback.

zWhen pre-alarm recording is performed, audio is not recorded.

Setting alarm triggers

Use this setting to indicate how alarms are to be detected.

1 Press the [MENU] button.

The MENU indicator lights up and the <MAIN MENU> is displayed.

MENU

2 Turn the jog dial to select “2.RECORD SET” and then turn the shuttle dial clockwise.

3 Turn the jog dial to select “7.ALARM REC MODE SET” and then turn the shuttle dial clockwise.

The <ALARM REC MODE SET> screen is displayed.

<ALARM REC MODE	SET>
ALARM RECORDING	: OFF
PICTURE QUALITY	: ENHANCED
PICTURE QUALITY SET	->
AUDIO RECORDING	: OFF
ALARM INTERLEAVE	: ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING	: ***
REC RATE: ***** FPS,	DURATION: *****
ALARM TRIGGER	: ALARM
MOTION SENSOR	->

4 Turn the jog dial to select “ALARM TRIGGER” and then turn the shuttle dial clockwise.

“ALARM” flashes.

<ALARM REC MODE	SET>
ALARM RECORDING	: ENABLED
PICTURE QUALITY	: ENHANCED
PICTURE QUALITY SET	->
AUDIO RECORDING	: OFF
ALARM INTERLEAVE	: ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING	: ***
REC RATE: ***** FPS,	DURATION: *****
ALARM TRIGGER	: ALARM
MOTION SENSOR	->

SETTINGS

98 English