Texas Instruments MATRIX 3000, DW30 user manual 26. Copy X/Y Values into All Projectors

Section 3: Operation

Figure 3.26. Copy X/Y Values into All Projectors

6.In each projector, judge by eye and adjust x/y coordinates slightly in the following manner:

‰To match reds, decrease “Red X” until full field red screens match.

‰To match greens, decrease “Green Y” until full field green screens match.

‰To match blues, increase both “Blue X” and “Blue Y” until full field blue screens match.

NOTE: For speed, enable the “Auto Color Enable” checkbox. Each color coordinate you select will then automatically trigger a full field display of the corresponding color.

Alternatively, use the Color Saturation menu for these adjustments or to fine tune.

These coordinate adjustments move the three color points closer together (refer back to the chromaticity chart shown in Figure 3.21.) to establish a “shared” gamut attainable by all projectors in your group. Adjust only as necessary to ensure that the resulting color palette is as large as possible. When done, you may need to adjust lamp power slightly.

013-100149-02 Rev. 1 (01/07) Christie DS+60/DW30/Matrix 3000 User’s Manual 3-57