Section 2
Installation & Setup
The instructions provided here are for those that are familiar with the projector and
2.1 Quick Setup wish to quickly set it up and use it temporarily. Refer to the remaining subsections of this manual for a more complete setup.
Step 1 f Install a Projection Lens
The projection lens is shipped separately from the projector and must be installed prior to setting up the projector. Install the projection lens as described in 4.5 Replacing the Projection Lens.
Remove the lens “plug” from the projector before installing a lens.
When shipping the projector, always remove the lens and reuse the lens plug. This will prevent dust and debris from entering and settling on critical optical components.
Step 2 f Position the Projector
Place the projector on a sturdy, level surface and position it so that it is perpendicular to the screen at a suitable distance. In general, the further back the projector is positioned from the screen, the larger the image will be.
If required, you can level the projector by adjusting its three feet. With the projector positioned perpendicular to the screen the image will appear rectangular instead of keystoned.
For more detailed instructions on positioning the projector refer to Projector Position and Mounting later in this section.
Step 3 f Connect a Source
Located at the back of the projector is the input panel where all source connections are made. Each input is clearly labeled for easy identification.
Using the appropriate cable(s), connect your source. Connect RGB and YPbPr sources to INPUT 1 located in the upper right corner of the input panel. Use the
NOTE: One of the available optional input modules can be installed at INPUT 5 for additional connections. Refer to 2.3 - Connecting Sources for more details on connecting a specific source.
Christie DS+60/DW30Matrix 3000 User’s Manual |
