Section 3: Operation
Error Codes f
Code Description
GENERAL
12Software bug. Contact dealer/factory.
13Flash memory corrupted. Download new software.
14Engineering only programming is complete. Call Christie, replace TIPM.
15Attempting to download code without being in boot mode
16Invalid interrupt. Power off/on. If it persists, contact dealer/factory.
17Forced boot mode. Keys held down too long.
18Attempting to program boot mode without jumper
LAMP FAILURES
21 | Lamp compartment too hot |
25Lamp 1 not installed
26Lamp 1 Interlock: door open, lamp not installed
27Unable to turn lamp 1 ON
28Lamp 1 shut off unexpectedly
29Lamp 1 driver overheated
2A | Lamp 1 driver operation error (e.g. too hot can’t start) |
2C | Lamp 1 driver UART communications failure |
30Lamp 2 not installed
31Lamp 2 door open
32Unable to turn lamp 2 ON (unknown reason)
33Lamp 2 shut off unexpectedly
34Lamp 2 driver overheated
35Lamp 2 driver reports operation error (e.g. too hot can’t start)
36Lamp 2 driver UART communications failure
37Lamp Watchdog Tripped – Unless lamps turn on again after 3 minutes, assume software hung.
POWER AND COOLING
41Lamp 1 driver Vcc to low
42Color wheel 1 stopped for at lease one second
44Lamp 2 driver Vcc too low
45Color wheel 2 stopped for at least one second
4C | Projector shutdown due to critical error |
51 | TIPM fan failed |
53 | Main blower failed |
56Engine fan failed
57Lamp 1 driver fan failed
58Lamp 1 fan failed
59Lamp 2 driver fan failed
5A | Lamp 2 fan failed |
TIPM (image processor)
60Boot code CRC failed
61Unable to program the DigMux PLD
62Unable to program the Control PLD
63Unable to program the BUBKS PLD
64Unrecognized ROM type
65Write to flash ROM failed
66General image processor failure
67Downloaded code will not fit in the ROMs
68Communication problem with scaler on image processor
BUILT-IN or EEPROM
70
71
72
73
Unable to access the EEPROM on the
EEPROM memory
Unable to access the EEPROM on the lamp module
Unable to access the EEPROM on the Back End Board
BACK END BOARD
80Unable to detect Back End Board
81Unable to program a device on the programming bus
82TI flash download failure – not started
83TI flash download failure – partial write
84TI flash download failure – checksum read
85TI – I2C write failure
86Communications failure
| BACKPLANE or OPTIONAL INTERFACE MODULE |
| ||
| A0 | Unable to program the Option Card |
| |
| A1 | Unable to power the Option Card |
| |
| A2 | Unable to program the Backplane module |
| |
| A3 | Unable to program the Warp Module |
| |
Clear system errors with Exit | Exit . If you encounter a system error, try resetting the projector by powering it off and on | |||
again (wait at least 90 seconds and allow for proper cooling). For detailed information, monitor the RS232 IN port. Contact dealer/factory if error persists and if a code appears that is not listed.
| Christie DS+60/DW30/Matrix 3000 User’s Manual |
