Exit Exit
Exit Exit

Section 3: Operation

should be reported to the manufacturer. You can press to remove the message, but for best results you should reset the projector—power the projector

down and up again with the (power) key.

System Errors

A system error message indicates that a serious malfunction has been detected and must be reported to the manufacturer as soon as possible (see Status LED Codes, below). The projector will no longer operate and must be reset—power the projector

down and up again with the (power) key.

The Status LED Codes

If the status code display on the back of the projector shows one of the following values, you have encountered a likely system error requiring the attention of a qualified service technician (see System Warnings and System Errors, above).

Acknowledge and clear the error with from presentation level, or try resetting the projector by powering it off and on again, cooling when necessary. Consult and contact your dealer if the problem persists.

The specific code number identifies the source of the error detected, and is particularly useful in cases where the projector is too far away to read the accompanying text message in the LED status display window. For example, the code “27” means “Lamp 1 could not be turned on”. Error codes for this projector are listed in the table below.

3-68 Christie DS+60/DW30/Matrix 3000 User’s Manual

013-100149-02 Rev. 1 (01/07)

Page 95
Image 95
Texas Instruments DW30, MATRIX 3000 user manual System Errors, Status LED Codes