Texas Instruments DW30 Lamps, Appendix G for the lamp product safety data sheet, Power Cord

Section 4: Maintenance

Projector Location f Operate the projector in an environment, which meets the operating range as specified in Section 6 – Specifications.

•Do not operate the projector close to water, such as near a swimming pool. Do not operate in extremely humid environments.

•Do not place the projector on an unstable cart, stand or table. A projector and cart combination should be used with care. Sudden stops, excessive force and uneven surfaces may cause the projector and cart combination to overturn.

•If the projector is to be ceiling mounted, use only the Christie-approved ceiling mount fixture.

Lamps	f The two 300W P-VIP lamps in the projector require replacement when they have
	reached their end of life (approximately 1500 hours), if they have failed during
	operation, or have a drastic change in brightness (typical of aging lamps). To
	effectively maintain operation of the projector it is best to be aware of any changes
	that occur in brightness and the number of hours each lamp is in use. Refer to 4.4.
	Lamp Replacement for more details on lamp replacement.
	NOTE: These are mercury-containing lamps. Handle appropriately. Refer to
	Appendix G for the lamp product safety data sheet.
	Follow all safety and warning precautions regarding lamp replacement and handling.
	WARNING
	Wait approximately 5 minutes to allow the lamp to cool
	before removing.
	Do not stick hands into the lamp compartment during
	lamp replacement.
	The lamp is under great pressure when hot and may
	explode causing physical injury and/or property damage.
	Allow a lamp to cool before handling and/or powering
	down and unplugging the projector.
	Use only the lamps supplied by CHRISTIE, in the Lamp
	Replacement Kit.
Power Cord	f Use only the attachments and/or accessories recommended by CHRISTIE. Use of
and Attachments	others may result in the risk of fire, shock or personal injury.
	WARNING
	Use only the AC power cord supplied. Do not attempt
	operation if the AC supply is not within the specified
	voltage and power range. See Section 6.
	• Do not set or rest items on the power cord. Place the projector in an area where
	the projector cord cannot be abused or damaged by persons walking on it or by
	objects rolling over it.
	• Operate the projector at the specified voltage only. Do not overload power outlets
	and extension cords as this can result in fire or shock hazards.

4-2 Christie DS+60/DW30/Matrix 3000 User’s Manual 013-100149-02 Rev. 1 (01/07)