Texas Instruments DW30, MATRIX 3000 user manual Contrast, 13 Blanking of a PIP Image, Exit or Menu

the menu (press

Section 3: Operation

PLUG & DISPLAY (EDID): By default, a Plug & Play (EDID) source outputs a signal according to the EDID information provided by the projector. To override this information and display in a different format (for example, if your Plug & Play [EDID] device does not support the projector’s resolution and/or frequency), select the desired Plug & Play (EDID) resolution from the list.

Any daisy-chained projectors will also display according to the chosen Plug & Play (EDID) format.

EDID = Extended Display Identification Data standard.

Figure 3. 13 Blanking of a PIP Image

Image Settings Menu f Use options in the Image Settings menu to alter your image without affecting its size or position. Changes made to the Image Settings menu are applied immediately and are saved when you exit

Exit or Menu ).

Options not available for the projector model or source are disabled and appear dim (gray).

Contrast

(SHORT CUT: Press Contrast and adjust the slidebar.)

“Contrast” increases or decreases the perceived difference between light and dark areas of your image (0-100). For best results, keep close to 50. If contrast is set too high, the light parts of the image lose detail and clarity. If set too low, the light areas will not be as bright as they could be and the overall image will be dim. For best results, start with a low value and increase so that whites remain bright but are not distorted or tinted, and that light areas do not become white (i.e., are “crushed”).

NOTE: If the environment lighting changes, an adjustment of Gamma is recommended (see below).

3-24 Christie DS+60/DW30/Matrix 3000 User’s Manual 013-100149-02 Rev. 1 (01/07)