
3 Tests and Diagnostics | 3.9 Async Test |
3.9Async Test
To execute the Async Test, select 7 from the DIAGNOSTIC TEST MENU, press Enter and follow the directions displayed on the screen. The Async test contains two subtests that test the asynchronous communication functions. Move the highlight bar to the subtest you want to execute and press Enter.
Subtests require the following data format:
Method: | Asynchronous |
Speed: | 38400BPS (Subtests 06, 07) |
Data: | 8 bits and one parity bit (EVEN) |
|
| Data pattern: 20h to 7Eh |
Subtest 01 | Wraparound (board) | |
|
|
|
|
| NOTE: To execute this subtest an |
|
| (34M741621G01) must be connected to the |
|
| wraparound connector wiring diagram is described in Appendix F. |
|
|
|
| This subtest checks the data send/receive function through the wraparound | |
| connector. | |
Subtest 02 | Point to Point (send) | |
|
|
|
|
| NOTE: To execute this subtest, two machines must be connected with an |
|
| |
|
| and the other set as “receive” (subtest 03). The wiring diagram for the |
|
|
|
|
|
|
| This subtest sends 20h through 7Eh data to the receive side, then receives the | |
| sent data and compares it to the original data. | |
Subtest 03 | Point to Point (receive) | |
| This subtest is used with subtest 02 described above. This subtest receives the | |
| data from the send side, then sends the received data. | |
Subtest 04 | Interrupt Test | |
| This subtest checks the Interrupt Request Level of IRQ 4, 3 and 5 from the | |
| send side. |
Satellite Pro M10 Series Maintenance Manual |