4.34 TFT FL (Model 15.0 UXGA SHARP LQ150U1LW13) | 4 Replacement Procedures |
7.Secure the TCP of the source PCB with three screws.
8.Secure the TCP of the gate PCB with two screws.
9.Connect the FPC to the connector on the source PCB.
| Make sure the latch secures the connector correctly. | |
| See the notches on both the edge of the FPC, and | |
| see the contour of the connector. | |
| Insert the FPC into the connector firmly. The FPC | |
| must have no inclination. Lock the connector firmly. | |
| NG: The FPC has inclination. | |
| NG: The FPC does not connect firmly. | |
Screw | Source PCB | |
Screw | ||
| ||
Screw |
|
Screw
Pin* | Pin* | Gate PCB |
|
| Screw |
Tighten the screws with 1.0 kgf•cm of torque.
*Align the holes on the PCBs with the pins.
Figure 4-142 Securing the TCPs and connecting the FPC
Satellite Pro M10 Series Maintenance Manual |
