Toshiba M10 manual Setup by OS, All Devices

3.28 SETUP 3 Tests and Diagnostics

(f)Panel Power On/Off

This option lets you set the Panel Power On/Off function. It is effective only in Resume mode.

Enabled	Enables the Panel Power On/Off.
Disabled	Disables the Panel Power On/Off (Default)

9.Configuration

This field displays the configuration method.

The devices are initialized when the PNP OS loads.

Setup by OS	First, devices necessary for loading the OS will be
	initialized. After the PNP OS loads, other devices will
	be initialized by the OS. In this case, setup of PC Cards
	will be fixed to “Auto-Selected,” and cannot be
	changed. (Default)
All Devices	All devices will be initialized.

If you are using an OS that does not have PNP capacity, select “All Devices.” The Display shows the following message:

Device Config. = All Devices

10.I/O ports

This option controls settings for the serial and parallel ports and the sound system.

NOTE: Do not assign the same interrupt request level and I/O address to the serial port and PC card.

(a)Serial

Use this option to set the COM level for the serial port. The serial port interrupt request level (IRQ) and I/O port base address for each COM level is shown below:

Satellite Pro M10 Series Maintenance Manual (960-431) 3-89