
6F3B0250
4.Installation and Wiring
4.6I/O wiring
! CAUTION 1. Turn off power before wiring to minimize the risk of electrical shock.
2.Exposed conductive parts of wire can cause electrical shock. Use
3.Turn off power before removing or replacing units, modules, terminal blocks or wires. Failure to do so can cause electrical shock or damage to the T1/T1S and related equipment.
·Refer to sections 2.4 and 3 for instructions on how to properly wire the I/O terminals.
·0.75 mm2 (18 AWG) to 0.3 mm2 (22 AWG) wires are recommended for I/O signals.
·Separate the I/O signal cables from
·If expansion rack or unit is used, separate the expansion cable from the power and I/O signal cables by or unit at least 50 mm.
·It is recommended to separate the input signal cables from output signal cables.
T1
200mm or more
Input signal | Output | |
| signal | cable |
80 T1/T1S User’s Manual
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net