COURIER HIGH SPEED MODEMS
When you make remote configuration changes, the remote prompt is altered to indicate that changes have been made. The prompt will change from:
Remote->
to
Remote+>
If you restore the original configuration (with %C1, explained next), the original prompt is also restored (back to
By default, configuration changes do not take effect until the connection is terminated (see %Cn). However, the new configu- ration is immediately reflected on the information screens (ATIn).
Remote Configuration Commands
There are some additional commands that are only executable during a remote access session. These commands are as follows.
%Bn Configure the Courier's serial port rate.
%B0 | 110 bps | %B6 | 9600 bps |
%B1 | 300 bps | %B7 | 19,200 bps |
%B2 | 600 bps | %B8 | 38,400 bps |
%B3 | 1200 bps | %B9 | 57,600 bps |
%B4 | 2400 bps | %B10 | 115,200 bps |
%B5 | 4800 bps |
|
|
%Cn Configuration control.
%C0 Defer configuration. This is the default. Configu- ration changes are deferred until the call is ended; they take effect for ensuing connections. You do not need to enter this command; it is the default unless you enter %C1 or %C2.
