COURIER HIGH SPEED MODEMS
Additional Result Code Subsets
NOTE: ARQ (Automatic Repeat Request) is used in this manual to denote calls under error control.
&An Enable/disable additional result code subsets. See the Xn command earlier in this chapter.
&A0 | ARQ result codes are disabled. This setting does not | |
| affect an error control connection; the modem returns the | |
| standard CONNECT messages if result codes are | |
| enabled. |
|
&A1 | ARQ result codes are enabled, indicating that a | |
| connection is under error control. Message 14 is | |
| displayed if the modem is set to X0 and the connection is | |
| at any rate from 1200 to 28.8K bps. The remaining results | |
| indicate the connection rate and require a setting of X1 or | |
| higher. |
|
| 14/CONNECT/ARQ | 57/CONNECT 16800/ARQ |
| 15/CONNECT 1200/ARQ | 88/CONNECT 19200/ARQ |
| 16/CONNECT 2400/ARQ | 94/CONNECT 21600/ARQ |
| 17/CONNECT 9600/ARQ | 100/CONNECT 24000/ARQ |
| 19/CONNECT 4800/ARQ | 104/CONNECT 26400/ARQ |
| 22/CONNECT 12000/ARQ | 108/CONNECT 28800/ARQ |
| 24/CONNECT 7200/ARQ |
|
| 26/CONNECT 14400/ARQ |
|
&A2 | Additional VFC, V34, HST, or V32 modulation indicator. | |
| Included for users of HST Dual Standard modems. If | |
| your software cannot handle the added modulation | |
| information, select &A1 or &A0. | |
23/CONNECT 9600/HST | 27/CONNECT 9600/ARQ/HST | |
28/CONNECT 4800/HST | 29/CONNECT 4800/ARQ/HST | |
30/CONNECT 7200/HST | 34/CONNECT 7200/ARQ/HST | |
31/CONNECT 12000/HST | 32/CONNECT 12000/ARQ/HST | |
35/CONNECT 14400/HST | 36/CONNECT 14400/ARQ/HST | |
53/CONNECT 16800/HST | 57/CONNECT 16800/ARQ/HST | |
33/CONNECT 9600/V32 | 37/CONNECT 9600/ARQ/V32 | |
38/CONNECT 4800/V32 | 39/CONNECT 4800/ARQ/V32 | |
40/CONNECT 7200/V32 | 44/CONNECT 7200/ARQ/V32 | |
41/CONNECT 12000/V32 | 42/CONNECT 12000/ARQ/V32 | |
45/CONNECT 14400/V32 | 46/CONNECT 14400/ARQ/V32 | |
83/CONNECT 16800/V32 | 84/CONNECT 16800/ARQ/V32 | |
87/CONNECT 19200/V32 | 90/CONNECT 19200/ARQ/V32 | |
Data Mode Operations
