USRobotics V.34 user manual FAX Service Class 2.0 Commands

COURIER HIGH SPEED MODEMS

FAX SERVICE CLASS 2.0 COMMANDS

Class 2.0 fax commands are too numerous to be listed here. For information on Class 2.0 technical specifications, contact Global Engineering Documents, at 1-800-854-7179. The document that covers this information is:

ANSI/EIA/TIA-592-1993 (EIA-592)

Asynchronous Facsimile DCE Control Standard

May, 1993

Optional Class 2.0 FAX commands supported

U.S. Robotics implements the following optional Class 2.0 fax commands :

+FNS=0,1	Pass-through non-Standard negotiation
	byte string
+FCR=0,1	Capability to receive
+FAA=0,1	Adaptive Answer mode
+FCT=0-255 sec.	Phase C Timeout
+FHS=0-255	Hangup Status Code, read only
+FMS=0-3	Minimum Phase C Speed
+FBS?=500,100	Buffer size, read only

V.25 BIS SYNCHRONOUS COMMANDS AND RESULT CODES

Commands: Connect incoming call (CIC); Call request using number provided (CRN); Call Request with memory location (CRS); Disregard incoming call (DIC); Program number (PRNn); Request list of forbidden numbers (RFN); Request list of stored numbers (RLN).

Dial options: 0−9 & : > < = P T);

Result Codes: Call failure indication (CFI) with optional

parameters: Abort call (CFAB); local modem busy (CFCB); Engaged tone (CFET); Forbidden call (CFFC); Number not stored (CFNS); Answer tone not detected (CFNT); Ring tone (CFRT); Connect (CNX); List of numbers (LS); List of forbidden numbers (LSF); List of stored numbers (LSN); Incoming call (INC); Invalid (INV) with optional parameters: Message syntax error (INVMS); Command Unknown (INVCU); Parameter syntax error (INVPS); Parameter value error (INVPV); Valid (VAL).

K-6 Technical Specifications