ADTRAN 1200305L1 system manual System Config Snmp Traps Destination Community

Section 4, User Interface Guide ATLAS 550 System Manual

SYSTEM CONFIG > SNMP > TRAPS DESTINATION > COMMUNITY

Write security: 3; Read security: 5

Defines the community name for trap destinations. This name must match the community name defined on the network management station (NMS).

SYSTEM CONFIG > SNMP > TRAPS DESTINATION > TRAP FILTERING

Write security: 3; Read security: 5

Sets the minimum severity level required for a system event to generate an SNMP trap. If a trap event occurs with a severity level equal to or more severe than the trap type’s current threshold setting, the event is sent as an SNMP trap. (Refer to the ADTRAN Technical Support web page (www.adtran.com) for a listing of all MIBs containing traps and their severity levels.) The available selections for the threshold levels are:

DISABLED, CRITICAL, MAJOR, MINOR, WARNING, NORMAL, and INFO.

SYSTEM CONFIG > SNMP > TRAPS DESTINATION > STATION TYPE

Write security: 3; Read security: 5

To deliver the SNMP trap packet with the COMMUNITY NAME unchanged, define the STATION TYPE as NORMAL. If you are using T-Watch PRO, define the STATION TYPE as T-WATCHMGMT and append the COMMUNITY NAME with “.ADLP ADDRESS.” Within the SNMP trap packet, this field is automatically updated before it is sent to the management station.

SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS

Write security: 3; Read security: 5

Defines performance threshold values for DS1 Line and Path statistics recorded in a 15-minute interval. Refer to the ADTRAN Enterprise MIB and the DS1 Extension MIB (available on the documentation CD or the ADTRAN website at www.adtran.com) for more MIB-specific information. If a statistic value exceeds its threshold value, then the corresponding Alert Trap will be sent if the Alert Event is armed and Alert Traps are enabled. These thresholds apply to all DS1 interfaces in the system.

SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT ES THRSH

Write security: 3; Read security: 5

The DS1 performance monitor Threshold Value for the Current 15 minute Errored Seconds (ES) parameter. The default value is 65 for an approximate BER level of 10E-5.

SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT SES THRSH

Write security: 3; Read security: 5

The DS1 performance monitor Threshold Value for the Current 15 minute Severely Errored Seconds (SES) parameter. The default value is 10 for an approximate BER level of 10E-5.

SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT SEFS THRSH

Write security: 3; Read security: 5

The DS1 performance monitor Threshold Value for the Current 15 minute Severely Errored Framing Seconds (SEFS) parameter. The default value is 2 for an approximate BER level of 10E-5.

84 © 2002 ADTRAN, Inc. 61200305L1-1F