ADTRAN 1200305L1 system manual Logging in to the System

LOGGING IN TO THE SYSTEM

Introduction

Once connected to the ATLAS 550 via either a VT100 terminal or PC configured as a VT100 terminal, it is necessary to log in to the system to gain access to the management and provisioning functions. This DLP provides specific steps for logging into the system and accessing the various management and provisioning functions.

Prerequisite Procedures

Complete DLP-001,Connecting the Terminal or PC to the CONTROL/CRAFT Port before logging in to ATLAS 550.

Tools and Materials Required

•Data cable to connect to a VT100 terminal or a PC configured as a VT100 terminal (shipped with unit)

•VT100 terminal or PC configured as a VT100 terminal

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic modules can be damaged by static electrical discharge. Before handling modules, wear an antistatic discharge wrist strap to prevent damage to electronic components. Place modules in antistatic packing material when transporting or storing. When working on modules, always place them on an approved antistatic mat that is electrically grounded.

61200305L1-1F © 2002 ADTRAN, Inc. 319