ADTRAN 1200305L1 system manual Modules NXT1HSSI Hssi Menus Config Port Name

ATLAS 550 System Manual Section 4, User Interface Guide

MODULES (NXT1HSSI) > HSSI MENUS > CONFIG

Write security: 5; Read security: 5

Provides configuration parameters for the HSSI interface including data clocking.

When using the NxT1 HSSI/V35 Module in V.35 mode, Data Set Ready (DSR) and Data Carrier Detect (DCD) are always active.

MODULES (NXT1HSSI) > HSSI MENUS > CONFIG > PORT NAME

Read security: 5

Accepts any alpha-numeric name up to 16 characters long, to uniquely identify the HSSI interface on the NxT1 HSSI and NxT1 HSSI/V.35 Option Modules

MODULES (NXT1HSSI) > HSSI MENUS > CONFIG > TX CLK

Write security: 5; Read security: 5

Controls the clock used by the NxT1 HSSI/V.35 Module to accept the transmit (TX) data from the DTE. This is usually set to NORMAL. If the interface cable is long, causing a phase shift in the data, the clock can be set to INVERTED. This switches the phase of the clock, which compensates for a long cable.

MODULES (NXT1HSSI) > HSSI MENUS > CONFIG > CTS (V.35)

Write security: 5; Read security: 5

(Available only on the NxT1 HSSI/V.35 Option Module - P/N 1200346L2.) Determines the behavior of the Clear To Send (CTS) signal. If set to NORMAL, CTS will follow the Request To Send (RTS) signal. If set to FORCED ON, CTS will always be asserted.

MODULES (NXT1HSSI) > HSSI MENUS > CONFIG > DSR (V.35)

Write security: 5; Read security: 5

(Available only on the NxT1 HSSI/V.35 Option Module - P/N 1200346L2.) Determines the behavior of the Data Set Ready (DSR) signal. If set to NORMAL, DSR will generally be asserted when the interface is capable of passing data. If set to FORCED ON, DSR will always be asserted. If set to REMOTE DTR, the value of DSR will track the value of the remote unit’s DTR signal.

MODULES (NXT1HSSI) > HSSI MENUS > CONFIG > IFCE AUTO DEACT

Write security: 5; Read security: 5

This feature allows a user to set an active DS1 threshold that is used to control the status of the module’s DTE interface. If the number of active DS1 links falls below the threshold while this setting is Enabled, the module’s DTE interface will be deactivated. The module will not automatically restore operation on the DTE interface until the number of DS1 links reaches the threshold value. The DTE interface may be manually activated.

The Interface Automatic Deactivation feature is not available when CA (data Communication equipment Available signal) is configured OFF or DCD (Data Carrier Detect) is configured FORCED ON.

61200305L1-1F © 2002 ADTRAN, Inc. 173