Digi 90000566_H manual Set pmodem, Enables modem emulation, Disables modem emulation

set pmodem

set pmodem

Devices supported

Purpose

Required permissions

Syntax

This command is supported in the following products:

•Connect Family: all products

•Digi Cellular Family: All products except Digi Connect WAN. Not supported in ConnectPort Display.

Used to configure various options for modem emulation over TCP/IP, and display current modem-emulation settings.

For Digi Connect products with two or more users, to use this command, permissions must be set to one of the following:

•For a user to display the modem emulation settings for the line on which they are logged in: “set permissions s-pmodem=r-self”

•For a user to display the modem emulation settings for any line: “set permissions s-pmodem=read”

•For a user to display and set the modem emulation settings for the line on which they are logged in: “set permissions s-pmodem=rw-self”

•For a user to display the modem emulation settings for any line, and set modem emulation settings for the line on which the user is logged in: “set permissions s-pmodem=w-self-r”

•For a user to display and set the modem emulation settings on any line: “set permissions s-pmodem=rw”

See "set permissions" on page 157 for details on setting user permissions for commands.

Configure modem emulation

The connection-type option, "telnet," applies to both incoming and outgoing calls via the pmodem feature.

set pmodem port=range [state={onoff}] [telnet={onoff}]

Display modem-emulation settings

set pmodem [port=range]

Options	port=range
	Used to specify the serial port. Optional on a single-port device.
	state={onoff}
	Used to enable or disable modem emulation on a given serial port.
	on
	Enables modem emulation.
	off
	Disables modem emulation.
	The default is “off.”

164 Chapter 2 Command Descriptions