Digi 90000566_H manual Set pppoutbound

set pppoutbound

set pppoutbound

Devices	This command is supported in Digi Cellular Family products only.
supported
Purpose	Configures Point-to-Point Protocol (PPP) outbound connections, or
	displays current PPP outbound settings.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display the pppoutbound settings:
	“set permissions s-ppp=read”
	• For a user to display and set pppoutbound settings:
	“set permissions s-ppp=rw”
	See "set permissions" on page 157 for details on setting user permissions
	for commands.
Syntax	Configure PPP outbound connections
	set pppoutbound port=range
	[state={enableddisabled}]
	[auth_method={nonePAPCHAPboth}]
	[passive={onoff}]
	[remote_address={negotiatedip address}]
	[local_address={negotiatedip address}]
	[address_mask=ip address mask]
	[default_gateway={yesno}]
	[protocol_compression={onoff}]
	[address_compression={onoff}]
	[header_compression={onoff}]
	[lcp_keepalive={onoff}]
	[lcp_ka_quiet_time=(10-86400 seconds)]
	[lcp_ka_max_missed_replies={(2-2550=ignore missed replies)}]
	[asyncmap=hex string]
	[chap_id=chap id]
	[chap_key=chap key]
	[pap_id=pap_id]
	[pap_password=pap password]
	[mru=256-1500]
	[mtu=256-1500]
	[n{1-4}=phone_number]
	[redial_attempts=attempts]
	[redial_delay=delay]
	[rx_idle_timeout=timeout]
	[tx_idle_timeout=timeout]
	[init_script=chat script]
	[dial_script=chat script]
	[login_script=chat script]
	[ipcp_dns_enabled={onoff}]
	Display PPP outbound settings
	set pppoutbound

166 Chapter 2 Command Descriptions