Digi 90000566_H manual Provision

	provision
provision
Devices	This command is supported in Digi Cellular Family products that have a
supported	CDMA (Code-Division Multiple Access) module.
Purpose	Provisions the CDMA module in a Digi Cellular Family device. Provisioning
	establishes configuration settings in the CDMA module for use in a mobile
	network. Examples of CDMA-based mobile service providers include
	Sprint, Verizon, Alltel, and Midwest. The CDMA module must be
	provisioned before you will be able to create a data connection to the
	mobile network.
	Provisioning needs to be performed once only. It is not necessary for Digi
	Cellular Family devices that use GSM (Global System for Mobile
	Communication).
	Provisioning is done either from the command line, using this command, or
	from the Web user interface, by launching the Mobile Device Provisioning
	Wizard from the Mobile Configuration page.
	Provisioning types
	There are several types of provisioning, each with different sets of
	parameters. Your mobile service provider can tell you which type is
	appropriate for your CDMA module.
	• Simple IP only (SIPONLY).
	• Mobile IP (MIP), which is a super set of SIPONLY.
	• IP-Based Over-the-Air (IOTA).
	• OTASP: Over-the-Air Service Provisioning (OTASP).
	Check with your mobile service provider for provisioning parameters
	The information that you need to specify during provisioning depends on
	your CDMA module and the settings that your mobile service provider has
	given you or already set up in your CDMA module.
	Contact your mobile service provider for the most appropriate provisioning
	type and the required provisioning parameters. Have the ESN (Electronic
	Serial Number) for your Digi Cellular device ready to give to the provider.
	This number is located on the label on the bottom of the device.
	Use “display provisioning” to get current provisioning parameters
	You can query for the currently configured provisioning parameters in the
	CDMA cellular module by entering a “display provisioning” command.

Chapter 2 Command Descriptions 53