Digi 90000566_H manual Item=reservation, Range=1-16all, Ip=ip address, Clientid=client MAC address

set dhcpserver

Options for configuring the scope's address reservations (“item=reservation”)

item=reservation

Specifies that the DHCP server configuration settings apply to the scope’s address reservations. You may use a reservation to create a permanent address lease assignment by the DHCP server. Reservations assure that a specified hardware device on the subnet can always use the same IP address. Address lease reservations associate a specific IP address with a specific client’s Ethernet MAC address.

action={setrevert}

Specifies the action to be performed by the “set dhcpserver” command.

set

Sets the DHCP configuration settings to the specified values. This is the default setting that is used if this option is not specified.

revert

Resets the configuration settings for the specified item to default values. This effectively removes the entry specified by the “range” option.

range={1-16all}

Selects the specific entry to which the action is to be applied.

enabled={onoff}

Enables the DHCP server feature on this Digi Connect product. Note that for the DHCP server to operate, the Digi Connect product must be configured to use a static IP address.

ip=ip address

The IP address reserved for the client. This value must not be the same as the IP address of the DHCP Server itself.

clientid=client MAC address

The MAC address for the client, for example, 00:40:9D:12:34:56.

leasetime={timeinfinite}

The length, in seconds, of the leases for the scope being served by this DHCP server. Specifying a time of 0 means that the default of using the scope’s lease time will be used. A DHCP client may request a lease duration other than this setting, and the DHCP server will grant that request, if possible. Leaving this option blank causes the default value specified in the scope to be used. That default will change whenever the scope changes.

Chapter 2 Command Descriptions 99