Digi 90000566_H manual Fromport=port number, Toport=port number

set socket_tunnel

Options state={disabledenabled

Enables or disables the configured socket tunnel.

timeout={0seconds}] {0 is no timeout}

The timeout (specified in seconds) controls how long the tunnel will remain connected when there is no tunnel traffic. If the timeout value is zero, then no timeout is in effect and the socket tunnel will stay up until some other event causes it to close.

from_hostname={nameip address}

The initiating host: the hostname or IP address of the network device that initiates the socket tunnel.

from_port=port number

The initiating port: the port number that the Digi device uses to listen for the initial socket tunnel connection.

from_protocol={tcpssl}

The initiating protocol: the protocol used between the device that initiates the socket tunnel and the Digi device. Currently, TCP and SSL are the two supported protocols.

to_hostname={nameip address}

The destination host: The hostname or IP address of the destination network device.

to_port=port number

The destination port: the port number that the Digi device uses to make a connection to the destination device.

to_protocol={tcpssl}

The destination protocol: the protocol used between Digi device and the destination device. Currently, TCP and SSL are the two supported protocols. This protocol does not need to be the same for both connections.

See also	•	"revert" on page 61.
	• "show" on page 249.
	•	The section on socket tunnel settings in your Digi product’s User’s
		Guide.

Chapter 2 Command Descriptions 201